If YOU are that person who does not use
their indicators at all ... OR ... who blinks them once and proceeds
when changing lanes or exiting an intersection because it is a pain
to use your turn signals the way they are? Then THIS is the
product for YOU. By simply touching your turn signal
switch up or down Once, the Blinking
Smart Lane Changer will flash your turn indicator lights an
additional 6 times allowing you to keep both hands on the wheel
more. No more holding and keeping your fingers on your turn
switch when changing lanes. Once you have used this product,
you'll never want to drive another car without it.
Did you know that failure to use your
indicators when turning or changing lanes is a ticketing
One Touch Lane Changer
Why does the Blinking Smart Lane Changer blink 6
times over the equivalent of about 5 seconds? The reason for
this is because of various studies done over the years by many
institutions regarding how people interrupt flashing lights.
The average person takes 1.5 seconds to see the first blink
(remember there not always looking where the flashing is coming
from), a split second for the brain to acknowledge this which leaves
approximately 3 blinks for them to know your intention and you to
make your maneuver. That’s why we use 6 times.
Comes complete with all connectors
We have all been behind someone whose blinker never goes off. You
become irritated and often make dangerous maneuvers to pass this
car. Don't let someone behind you become irritated because you have
not signaled properly or have forgotten to turn off your indicator
after changing lanes. Make life easier with a Blinking
Smart ONE TOUCH Lane Changer.
Broken turn signal switch? No Problem!
Why pay $300 or more to replace the broken indicator switch when can
use the Blinking Smart ONE TOUCH Lane Changer instead.
Save time AND money by ordering your Blinking Smart Lane Changer
Blinking Smart ONE TOUCH Lane Changer should work
on most vehicles that have separate rear brake and indicator
lights. It is easy and simple to install. It can fit
either under the hood or in the trunk by connecting the device wires
to the existing indicator circuit. Simply follow the wiring
instructions supplied with your Blinking Smart Lane Changer or you
to view the Installation instructions.
If your automobile (i.e. Porsche 928 /944) that only has a single
dashboard turn signal indicator light, the Blinking Smart
One Touch Smart
Lane Changer will not be able to flash this single indicator
light when flashing your turn signals. Because of this, you
might not be able to tell that your Blinking Smart unit is working
properly. To solve this problem, the
Smart Lane Changer
Plus version provides an extra
Output" that can be used to flash an alternate in-dash or
add-on light to show when the Blinking Smart Lane Changer
has been activated.